Whirlpool Repair
Whirlpool Washer Repair
Whirlpool washer showing F5 E2, F9 E1 or F8 E1, or humming without agitating? We test lid locks, pumps, shifters and couplings and explain the fix first.
Open 24 hours, 7 days a week
Schedule Your Repair
Service Type
What type of service do you need?
Or call us directly:
(813) 412-5186Washer Brands We Repair
Houses, Apartments & Condos Across the Tampa Bay Area
We repair refrigerators, washers, dryers, dishwashers, ovens, ranges and the rest of the kitchen and laundry room in homes across Tampa, St. Petersburg, Clearwater and the rest of the Tampa Bay area. A technician diagnoses the problem first, explains what failed and why, and gives you the price before any work starts.
How It Works
Tampa Bay Area
Ready to schedule your repair?
Tampa ProFix Repair: in-home appliance repair across the Tampa Bay area, with the price agreed before any work.
About Whirlpool Washer Repair
Two very different machines wear the Whirlpool washer badge. The top-loaders use a tall agitator or a low impeller, lock the lid while they agitate and spin, and switch between wash and spin with a shifter, linked to the motor by a drive coupling or belt and a gearcase. The front-loaders descend from the Duet line, with a horizontal drum, a drain pump, a rubber door boot and an electric door lock.
Whirlpool top-loaders report a lot through their codes, which makes the first minutes of a visit productive. F5 E2 means the control could not confirm the lid had locked. F9 E1 flags a drain that took too long, usually a blocked pump or a kinked hose. F8 E1 is slow fill, which often comes down to plugged inlet screens or a faucet that was never opened all the way.
A washer that fills and drains but leaves the agitator motionless has a mechanical problem. The shifter may not be moving the drive into wash mode, the coupling between motor and gearcase may have worn through, or the agitator dogs may have stripped. Owners usually describe the motor humming along with nothing moving. Grinding or banging in spin sends us to the tub bearing, suspension springs and dampers.
On the front-load side, drain complaints look the same, and many models have a pump filter you can reach through a small access panel low on the front. The extra Florida issue is the boot. Garage laundry areas stay warm and damp, mildew settles into the gasket folds and dispenser, and the machine starts to smell. Wipe the boot and leave the door cracked between loads. Homes on wells should also clean the inlet screens.
Lid locks, drain pumps, inlet valves, shifters and couplings are all reasonable repairs on a Whirlpool washer, and several of them are parts we keep on the van. The math changes when a top-loader's gearcase or tub bearing gives out after many years of service. At that point we put the repair cost next to the price of a new machine and let you make the call.
Where Whirlpool Washers Tend to Fail
- Lid lock or its switch failing, cycle stops with F5 E2
- Drain pump blocked or kinked drain hose triggering F9 E1
- Inlet screens plugged with sediment, slow fill code F8 E1
- Worn drive coupling, shifter or agitator dogs, motor hums but nothing moves
Whirlpool Washer Problems We Fix
Other Whirlpool Appliances We Repair
Washer Repair by Area
What washer owners run into in each part of the Tampa Bay area, from housing and water to building access. For how washers fail and what to check first, see our washer repair guide.
Still have questions?
Call us or book online for an in-home visit anywhere in our Tampa Bay service area.